Charger Type |
Linear Charger |
Number of series cells |
1 |
Power Supply (Min) (V) |
4 |
Power Supply (Max) (V) |
5.5 |
Charge Current (Min) (mA) |
2 |
Charge Current (Max) (mA) |
512 |
VOREG |
Programmable |
VOREG (Min) (V) |
3.6 |
VOREG (Max) (V) |
4.545 |
Control Interface |
IIC |
Operation Mode |
Host Control |
IO Logic Level (V) |
1.8 |
Temperature |
-40℃~85℃ |
Special Function |
NTC |
Package (mm) |
WLCSP 1.68X1.68-9B |
Charge Voltage Regulation Accuracy:
±0.5% ( 0°C to 50°C )
Charge Current Accuracy: ±5%
Maximum 28V Input Voltage Rating with Over-Voltage Protection
Minimum -5V Input Voltage Protection
Complete Charge Process with Pre-Charge, Fast Charge and Constant Voltage Regulation
Programmable Charge Parameters Through I2C Compatible Interface
Programmable Charge Termination and Autonomous Recharge
Wide Range of Fast Charge Current: 2mA~500mA
Strong and Robust Protection: VIN OVP, Battery OVP, OCP, Reverse Leakage Protection, Short Protection, Thermal Protection, PCB Over Temperature Protection
BATFET Control to Support Shipping Mode
System Reset Function
Fully Integrated Power Path Management
Ultra-low Battery Leakage Current to Support Shipping Mode
WLCSP 1.68mm×1.68mm×0.63mm-9B, 0.5mm Pitch Package
7-bit slave address (A7~A1) is 1001001 binary(0x49H)
IEC62368-1 Approved-File No.BE-37454
The AW32001E is a highly-integrated Li-Ion/Li-Polymer battery linear charger with system power path management. The charge process of AW32001E includes: Pre-Charge, Fast Charge and Constant Voltage Regulation. The charge parameters and operating modes are programmable through I2C interface. The charge process runs automatically and recharging occurs when the battery voltage drops below VBAT_REG-VRCH after the charge done status.
The AW32001E is targeted at space limited portable applications. The chip can take input power from either an AC adaptor or a USB port to supply the system load and charge the battery. Meanwhile, the chip provides system short circuit protection function by limiting the current from the input to the system and the battery to the system. These features are effective to protect the battery or chip from damage. The parameters of input current limit, the discharge current limit and safety timer can be programmed by the I2C interface. Additionally, input over voltage protection, input under voltage lockout and input headroom voltage are integrated for good input source detection.